Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRST: Problem with E1 PRI on MGCP Gateway

Hi,

In a small one site solution where we have a single CCM 4.2.3 server, Voice Gateway in a 2801 with SRST connecting via PRI to the central office a problem occurs when the SRST function kicks in.

The PRI interface stays down and will not allow answer or placement of calls.

I know it is probably a simple config error, but I have not been able to sort it out.

Any help highly appriciated.

Thanks!

Klavs

3 REPLIES
Silver

Re: SRST: Problem with E1 PRI on MGCP Gateway

At the cco you have a good example, take a look and compare it with your solution, it can be helpful to see if you have a configuration error:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f8b31.shtml

Regards

Silver
Silver

Re: SRST: Problem with E1 PRI on MGCP Gateway

Just a side note. Make sure the 'PRI Backhaul' ports UDP2427 & TCP2428 are not being blocked anywhere along the path lying in between the gateway and CCM.

Before that can you pls post the output from gateway show isdn status?. Try this command out few times since it is possible the status can change be continuously.

Let us know how you get on.

Ajaz

191
Views
0
Helpful
3
Replies