We are using SRST 12.4(15T) along with CCM ver 6.0. The problem which we are facing is that when CCM goes down , IP phones working switch over to SRST router but in SETTINGS-DEVICE CONFIGURATION under IP phone , IP phone still shows CCM as ACTIVE & SRST AS STANDBY which takes a long time to get refresh.Sometimes we need to reset the IP phone also.Same was happening from SRST to CCM switchover but we have configured keepalive as 10 seconds under call-manager-fallback in router & is working fine.
Is there any option in CCM version 6.0 where we can change this paramter?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...