I have one router 2851 ios 12.4(11)T and working with SRST v4.0 connected to PSTN. I have one ata 186 (SCCP version 3.02.01(050429A)but i can?t receive faxes from PSTN . In config guide say
"For ATAs that are registered to a Cisco Unified SRST system to participate in FAX calls, they must have their ConnectMode parameter set to use the "standard payload type 0/8" as the RTP payload type in FAX passthrough mode. For ATAs used with Cisco Unified SRST 4.0 and higher systems, this is done by setting bit 2 of the ConnectMode parameter to 1 on the ATA."
Is that 0X90000404????? or what value?
audio mode i have 0X00350035
In gateway what i need to config fax passtrough???
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4