Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST

I have cisco 7940's and 7960's with a 2821 router and CUCM 7.1.2. I was wondering where do the phones get the profile from in SRST mode? more specific, how do I change line appearences in SRST

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: SRST

The phones use the line appearance which it has when registered to CM.  The phone has memory of this, so when it fails to SRST mode, it will use the same provisioning.  No provisioning is sent from SRST to the phone in regards to DNs/line appearances.  The phone actually sends the information to SRST.

The phone knows where to fallback to SRST for based on the SRST reference which is defined in CM for the device pool, and it is placed in the phone config file.

2 REPLIES
Cisco Employee

Re: SRST

The phones use the line appearance which it has when registered to CM.  The phone has memory of this, so when it fails to SRST mode, it will use the same provisioning.  No provisioning is sent from SRST to the phone in regards to DNs/line appearances.  The phone actually sends the information to SRST.

The phone knows where to fallback to SRST for based on the SRST reference which is defined in CM for the device pool, and it is placed in the phone config file.

New Member

Re: SRST

I thought this would answer a question I had about inward dialing not working, but it didn't.  No fault to you though, you answered the question I asked.  I am going to post another if you want to watch for it

145
Views
0
Helpful
2
Replies