Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRTP config example for voip trunks

SRTP config example for voip  trunks

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: SRTP config example for direct h323 trunks

MGCP doesn't fit your requirements but you could use h323. You would need to configure ipSec to support the call signaling (if you want) and SRTP to support the media. Here is a Cisco write up on Media and Signaling encryption for IOS gateways:

https://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/htsecure.html

HTH.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

6 REPLIES

Re: SRTP config example for direct h323 trunks

MGCP doesn't fit your requirements but you could use h323. You would need to configure ipSec to support the call signaling (if you want) and SRTP to support the media. Here is a Cisco write up on Media and Signaling encryption for IOS gateways:

https://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/htsecure.html

HTH.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Re: SRTP config example for direct h323 trunks

if you use IPsec and you have any concern about QOS make sure to enable pre classify feature on the ipsec tunnel for QOS to make sure you keep the traffic marking and to avoid any qos issues

Re: SRTP config example for direct h323 trunks

I think that the original poster is looking for information on SRTP not SRST.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Re: SRTP config example for direct h323 trunks

thanks for that

New Member

Re: SRTP config example for direct h323 trunks

Hi All ,

I found it , here is the sample config


voice-card 1
codec complexity high
local-bypass


conf t
voice service  voip
sip 
url sip
srtp negotiate cisco
exit
exit


conf t
dial-peer voice xxx voip
srtp
srtp system
security mode encrypted
exit

regards,

Kursat

New Member

Re: SRTP config example for direct h323 trunks

Hi,

can i ask some question about the SRTP protocol?

1. how can i configure the SRTP protocol for bandwidth guarantee in QOS rules;

2. what is the SRTP port used?

3. what is the ios for the SRTP command in dial-peer?

3354
Views
0
Helpful
6
Replies