We used to be able to ssh into the 79xx phones by setting up a un/pw account for the phone and then using default/user to get into the phone. This seems to no longer work for 69xx or 89xx models. Anyone know if there is a new way to do this?
Most newer phones have a 'Secure Shell Information' section above the 'Product Specific' section on the device configuration page in CCMAdmin. Set a username and password there, and you should then be able to get SSH access.
I believe that the phones are locked down to support Midlets signed by Cisco only initially; with a future possibility of opening up the API. Is this not the case? I'd be interested to hear what you have to do to get your code running on them.
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...