Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SSHv1 / SSHv2 support for Cisco IOS on VG224

Hi

We are trying to configure the SSHv1 or SSH v2 on VG224 with vg224 Software (vg224-I6S-M), Version 12.4(12)(vg224-i6s-mz.124-12), however there doesnt seem to be any supported commands on the IOS release.

Anyone tried SSH configuration on VG224 analog gateways, and which IOS release to be used?

Thanks.

6 REPLIES
Cisco Employee

Re: SSHv1 / SSHv2 support for Cisco IOS on VG224

The IOS you're using does not support SSH

It needs the IP SUBSET/IPSEC 64 BIT/VOICE

The IOS name should contain a K9 in case it's enabled for it

IE

vg224-i6k9s-mz.124-15.T5.bin

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: SSHv1 / SSHv2 support for Cisco IOS on VG224

Also, would this support SSH version 1 or 2?

Re: SSHv1 / SSHv2 support for Cisco IOS on VG224

With the k9 image it will support both v1 and v2.

-nick

New Member

Re: SSHv1 / SSHv2 support for Cisco IOS on VG224

Thank you java and nick !

New Member

SSHv1 / SSHv2 support for Cisco IOS on VG224

I am running 12.4.22.T5 and can only get SSH V1 to operate. If I specify SSH V2 I get no connection. I am using a 2048 modulus on the key. Any thoughts?

New Member

Re: SSHv1 / SSHv2 support for Cisco IOS on VG224

We  have the same issue too, we have IOS  vg224-i6k9s-mz.150-1.M3.bin and higher on our VG 224's .

Never able to get SSH v2 working on the them, SSH v1 works fine .

also we use a modulus 1024 key .  Some body advise ??

---

Thanks,

Indu.

1315
Views
8
Helpful
6
Replies
CreatePlease to create content