we have in our company two CME router and we make HSRP betwwen the two CME to make the redandancy and the redundancy is working fine ...
the problem is we have some of the Phones are connected through DSL ( direct connection ), sometimes we found the phone not register to the active CME and when we open the HTTP page for the phone and going to the Network configrations menu it shown that the Callmanager 1 is Standby!!!!!!!
and the phone is sending standby keepalive to the CME all the time
when we reset the phone it's working fine and after some time this problem happen again
i'm thinking mayby the problem with the keepalive period ??? please i need help for this issue
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...