Good Evening Guys.... Hopefully just a quickie... Ive recently set up a lab at home, for testing purposes. I have the phone an CCM an switch all setup an pinging each other, but the phone just keeps registering.. so after a investigation ive noticed that none of the services are starting, after doing a "show utils service list"
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.