Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

stcapp uc520 uc500 and mac address

Hello everybody,

I would like to use the 4 FXS port of my UC500 as normale ephone using stcapp.

Where can I find the mac address to configure into the ephone statement relevant to the FXS port?

Thank you very much

Johnny

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

Re: stcapp uc520 uc500 and mac address

Similarly to your ATA case, enable auto registration and observe which mac are actually presented. The next available ephone tag will be used, you the place the correct mac under it.

Re: stcapp uc520 uc500 and mac address

Hi,

You move the Chassis MAC over three digits, and then add the voice-port number. 0/0/1 becomes 001, etc.

Here's a guide on it:

http://www.cisco.com/en/US/docs/routers/access/vg202_vg204/software/vg2_vg4_voip_ps2250_TSD_Products_Configuration_Guide_Chapter.html#wp1059863

hth,

nick

4 REPLIES

Re: stcapp uc520 uc500 and mac address

From my UC520:

nicmatth-sip(config)#do sh diag | I Chassis MAC

Chassis MAC Address : 001d.45b9.6980

hth,

nick

New Member

Re: stcapp uc520 uc500 and mac address

I need 4 mac address, one for each voice port in order to set it into any ephone

I think there should be a way to know them.

otherwise how can I configure my ephone referred to the voice ports?

Hall of Fame Super Gold

Re: stcapp uc520 uc500 and mac address

Similarly to your ATA case, enable auto registration and observe which mac are actually presented. The next available ephone tag will be used, you the place the correct mac under it.

Re: stcapp uc520 uc500 and mac address

Hi,

You move the Chassis MAC over three digits, and then add the voice-port number. 0/0/1 becomes 001, etc.

Here's a guide on it:

http://www.cisco.com/en/US/docs/routers/access/vg202_vg204/software/vg2_vg4_voip_ps2250_TSD_Products_Configuration_Guide_Chapter.html#wp1059863

hth,

nick

606
Views
0
Helpful
4
Replies
CreatePlease to create content