We recently set a new remot site location to have fax dialtone from an fxs card on a 2811 gateway. We have the lines connected to the equipment in the office but when we try to fax to it we get a normal handshake that fades out, and no fax transmission?
Anyone have any insight on this? We are trying to track down where thes issue is. Any suggestions or recommendatons would be a great help.
We have never used T.38 Fax Relay before and we haven't run into this issue. We are using an FXS card on a 2811 ISR gateway router for analog dialtone as we do in many of the offices. What does T.38 fax relay do for this scenario?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...