I have one user at a remote site who is having the following problems - I have done all the basic checks, swapped out phone, replaced CAT5, swapped switch port etc.. has anyone ever come across similar issues?
CM 4.1 Local H323 gateway.
It is very sporadic, the symptoms are;
â¢ Says 'connected' even when the handset is put down and the call is disconnected.
â¢ Says 'ringing out' even when the handset is put down and the call is disconnected.
To sum it up, I think the display is not updating with actions carried out on the phone.
All displays are corrected when the handset is lifted and then replaced.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.