Strange outage - Cannot make external calls only from remote locations
We have some strange outage in our phone system. We have CUCM 6.1 in the main office with 3 remote sites. These Remote sites are connected via MPLS to the CUCM in the main office. This morning suddenly, the remote locations cannot make outgoing (external) calls. But they can receive and make internal phone calls. They can even make and receive calls from our cluster CUCM in the other city (another CUCM connected via ICT and using the same MPLS)
These Remote sites don't have a direct numbers so all of the incoming calls are routed to the main office and then transferred to the remote location. Incoming seems not to be the problem; the problem was outbound external calls from remote sites.
First, I thought it was PRI/Gateway but the main office has no issue making and receiving external calls. It was kind of strange since the Remote locations outgoing external calls will go to the same PRI/GW as the main office.
I have no idea and the problem was fixed before I was able to debug the gateway. Anyone have any idea where should I start investigating the root cause of the issue? Is it the Telco (PRI), GW, CUCM or MPLS?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...