Stream from SRST MoH server not being played on IP Phones
I am trying to configure my SRST router to play MoH to the IP Phones of that site, without success for the time being.
The IPmc layer is working properly, since I saw the LAN switch (between the SRST router and the phones) building the IPmc tree from the SRST LAN to the IP Phone destination LAN when the phone is put on hold.
Moreover, I also verified that these IP Phones on the site of the SRST router are playing the music just fine if it comes from CUCM itself via multicast across the WAN. So the MRG, MRGL, AudioSource, MoH server seem to be correctly configured on the CUCM side.
I need your help to start debugging the problem, and in this context I have some basic questions:
1. ¿How does the router know the TTL of MoH packets? ¿Does it inherit this information from CUCM? I have not seen any IOS command that tells it how to configure the TTL parameter. Unfortunatelly, I am not able to deploy a sniffer on the remote side to see the TTL of the packets coming out of the SRST router.
2. The following is the output of a couple of show commands in the SRST router:
VG01New# show ephone summary
Active MOH clients 0 (max 830), Media Clients 0, B-ACD Clients 0
File SampleAudioSource.wav type WAVE Media_Payload_G711Ulaw64k160 bytes
Moh multicast on 22.214.171.124 port 16384 via 126.96.36.199 via 188.8.131.52
3. After reading the configuration guide, I am not sure whether the MoH Server must be in a G.711 region. ¿Is this really a requirement? I am asking this because I found that the CUCM administrator has already configured the MoH Server in a G.722 region.
Re: Stream from SRST MoH server not being played on IP Phones
I found what the problem was! As I feared in my first note, I had to setup a custom region with G.711 relationship between the MoH resource and the regions where I wanted IPmc MoH to be played. That solved the issue.
IPmc address/port was already the same in CUCM and the SRST router.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...