Strip off Connected party digits CUCME

[asharsidd]

We have a CUCME router connected to a E1 PRI circuit. All outgoing calls must be prefixed with a carrier pre select code of 1320 for cable and wireless to route the calls correctly.

We are experiencing an issue whereby the connected number display on the phone is displaying the prefix for PSTN calls and the customer is complaining that this is not acceptable.

There appears to be a way to stop this behaviour in the full version of CUCM but I cannot find any solution with CUCME.

Can anyone help?

!

dial-peer voice 5 pots

corlist outgoing call-local

description ** Local Numbers **

destination-pattern 9[1-9]......

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

port 0/0/0:15

forward-digits 7

prefix 132

!

[Hythim Ali El Hadad]

As you use CME

Then the digits sent to PSTN will appear in your calling IP Phone

Try to use voice translation-profile to add your 132 digits instead of using the prefix command in the dial-peer

it will help as i though

Regards

Haitham

[asharsidd]

Hello,

The voice translation rule did not resolve the issue.

Any more feedback?

[paolo bevilacqua]

To my knowledge, connected number display cannot be manipulated.