I have four subscribers in my CUCM cluster. I noticed that my backup log had errors so I ran "utils dbreplication runtimestate" on the pub and one of the subscribers shows replication state as off-line and the replication setup shows "(4) Setup Completed"
All other subs are working fine. Someone suggested that I run "utils dbreplication stop" on the sub and then "utils dbreplication repair (subname)" on the pub. When I do that I get a message "Selected node g_xxxxxx_ccm8_5_1_11900_21 does not appear in this replication network; aborting repairl operation for that node"
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...