Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

super g3 fax using an ATA 187

                   I can't get this working. I thought at first it was a sip provider issue but switched over to a pri with same result. I can get inbound faxes but cannot get outbound to work. I have tried almost everything I can think os  s3-to-g3, fax rate disable, ecm disable of the dial peers setting the rate to 9600 on the ata all with no success.  thx

166
Views
0
Helpful
0
Replies