Hi all, I just have a quick question. What is the difference between the supplementary-service & allow connections commands? As far as I can see, they are both used to enable the CME router to forward calls. So why are they two different command sets?
To allow connections between specific types of end points in a Cisco Multiservice IP-to-IP Gateway, use theallow-connections command in voice service configuration mode. To refuse specific types of connections, use the no form of this command.
allow-connections from-type to to-type
no allow-connections from-type to to-type
To enable individual dial peers to send H.225 messages with caller-ID updates, use the supplementary-service h225-notify cid-update command in dial peer configuration mode. To disable the sending of H.225 messages with caller-ID updates, use the no form of this command.
and To specify that calls are using QSIG and require supplementary services for call forwarding, use thesupplementary-service qsig call-forward command in voice-service or dial peer configuration mode. To return to the default, use the no form of this command.
supplementary-service qsig call-forward
no supplementary-service qsig call-forward
For the further description following URl may help you
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...