I'm working on upgrading c6500 sw from cat to native.
On call manager 4.2(3), when I add CMM module as a gateway. I only see the ws-6600 and <none>, am I unable to see the act and cmm6T1 on the ccm.
Is there an additional installation or addon/patch to ccm I need to set up for it to read the card correctly? Or am I able to just work around this by doing it all through CLI on the switch. Any recommendations or advice?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...