Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Swichport qos config for cisco voice gateways and call managers servers

I have enabled auto qos for the switchports (cat 3750) connecting to the user's cisco ip phones.. However, I am not sure if the switchports where any of the other devices need to have qos enabled - i.e. cisco routers (voice gateways), call manager servers, etc. I think it would make sense that switchports where voice gateways are connected would need to have qos enabled. But I can be wrong. Can anyone assist? Thanks.

Marramix

2 REPLIES
VIP Super Bronze

Re: Swichport qos config for cisco voice gateways and call manag

QoS needs to be configured anywhere that voice/video traffic may travel. This would definitelly include the switch ports that PSTN gateways and UC servers (UCM, Unity, CCX, etc).  You may want to read the QoS SRND to get started: Enterprise  QoS Solution Reference Network Design Guide Version 3.3

Super Bronze

Re: Swichport qos config for cisco voice gateways and call manag

Hi

You would want to configure the port as a trusted port.

So for autoqos:

Auto qos voip trust

In addition, if the port is an access (i.e. non-trunk port) you must configure the port to trust DSCP as there will be no CoS markings.

So:

Auto qos voip trust

Mls qos trust dscp

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
553
Views
0
Helpful
2
Replies
CreatePlease to create content