Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

switch type primary-qsig....

A customer has a siemens hicom conected to a 3745 router via e1-pri.

the following is the sinaling config:

interface Serial1/0:15

no ip address

encapsulation hdlc

no logging event link-status

no snmp trap link-status

isdn switch-type primary-qsig

isdn timer t321 0

isdn overlap-receiving T302 3000

isdn incoming-voice voice

no cdp enable

..........

my question is: what type of gateway can i use on a cisco unified communication manager 6 that i will integrate to the voice system?... e1-pri ?.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: switch type primary-qsig....

Sure.

Chris

4 REPLIES
Hall of Fame Super Silver

Re: switch type primary-qsig....

The 3745 is just fine, any ISR router 28/38XX will be optimal depending on number of PRIs required.

Chris

Community Member

Re: switch type primary-qsig....

ok but my question is...if I can add the 3745 as mgcp gateway with qsig signaling?.

RJB

Hall of Fame Super Silver

Re: switch type primary-qsig....

Sure.

Chris

Re: switch type primary-qsig....

I assume that you are asking about whether to use a H.323 gateway or an MGCP gateway. In either case, the 3745 will support it, depending, of course, of the IOS feature set you have. And either will work with CUCM 6.X and with the E1-PRI.

1085
Views
0
Helpful
4
Replies
CreatePlease to create content