Hello all...have a problem that I was hoping someone could provide an answer for. We are a small medical facility with a switchboard that is occupied until about 8:00PM. At that time they forward incoming calls to the nurses station. Is there a way that calls after 8:00PM (until 6:00 AM) could be forwarded to not only the nurses station but to another location (ER Desk) as well? I set up the Nurses station extension on the ER desk as well but they do not like that as it rings during the day as well. Any thoughts... CCM 5.1.
There is no built-in functionality for Call Forward All to go to multiple numbers so this is where you have to get a little creative :) Maybe you could install a "new" After Hours DN xxxx on both the Nurses station and the ER desk that is strictly for the Night forward. This number xxxx wouldn't ring during the day but when the switchboard forwards to xxxx after 8:00PM both phones will ring and the call can be answered at either.
Rather than adding a new DN to each phone, you could just put the existing ones into a Line Group, and have it forward to that line group after 8pm, and it would then ring on any lines you've placed in the hunt group.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...