Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Synchronizing databases between active and inactive partitions

I am performing an upgrade on quite a few CUCM servers, going from 6.x to 7.x.  I would like to install the upgrades one night and then reboot the servers to the upgraded partition a few nights later.  This causes problems if there are changes to the database between those two dates (and there definitely will be changes).  Is there a way that I can synch the database from the old partition to the upgraded partition when I do the switch-version?

1 REPLY

Re: Synchronizing databases between active and inactive partitio

While I am sure it varies depending on source and target versions (and there may be bugs logged), some data is synchronized on switchover.   User facing features like CFA, MWI, etc. are synchronized when you execute a "utils system switch-versions" command (I assume it works the same from the web portal).  You can also specify a version switch without the sync.

HTH.

Regards,
Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

357
Views
0
Helpful
1
Replies