Is it possible to to anything other than E&M on a T1 CAS port plugged into a 3845 MGCP gateway? CCM is 4.2(3). I need to talk to a legacy IVR via loop-start. The only option I'm given on the CCM gateway config page is E&M.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.