Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

T1-CAS cannot receive DID calls

I have a mgcp gateway using a T1-cas line with 5 trunks. Outbound calling works fine, inbound calling gets dialtone and then fast busy. Dial peer configuration is as follows

dial-peer voice 5 pots

description T1-CAS

service mgcpapp

port 0/2/0:1

debug voice dial-peer shows dnis hitting gateway. Any help is appreciated

4 REPLIES
Blue

Re: T1-CAS cannot receive DID calls

Pete,

Has this ever worked correctly?

If yes, then try a Call Manager gateway reset. I recently had a very similar problem that was resolved by reloading the router (2801).

If this is a a new install, debug cas, and work with the telco. Is this E&M wink?

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_chapter09186a008020ecf6.html

Please rate helpful posts.

Dave

New Member

Re: T1-CAS cannot receive DID calls

no, it has never worked. it is a new install. yes, the ports are e&m wink start. I will try the document, and resetting gw. thx

Hall of Fame Super Silver

Re: T1-CAS cannot receive DID calls

How is your GW configured in CM, how many digits are you expecting, is the CSS configured properly?

Chris

New Member

Re: T1-CAS cannot receive DID calls

i am expecting 4 digits, the gw and the phone are in the same css

254
Views
0
Helpful
4
Replies