Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

T1 e&m - 2 way problems. Urgent Please!

Hi

I am having problems with a T1 circuit (ESF, B8ZS and E&M Winkstart) and CallManager 4.2.

controller T1 1/0

framing esf

linecode b8zs

ds0-group 0 timeslots 1-24 type e&m-wink-start

!

This is terminating on a 2621XM with a NM-HDV.

I can successfully make inbound and outbound calls depending on having the port line in on the pots dial-peer.

If I have the port line in on the pots dial-peer, I can make outbound calls but inbound calls fail. On debug of voice vtdp inout I see there is no Called number. Debug attached.

voice-port 1/0:0

translate called 1

bearer-cap Speech

!

!

!

!

dial-peer voice 9 pots

tone ringback alert-no-PI

destination-pattern 9.T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

progress_ind disconnect enable 8

fax rate disable

direct-inward-dial

forward-digits 11

port 1/0:0

If I take out the port line from the pots dial-peer inbound calls work and the deb shows the called number. But obviously the outbound doesn't work.

I dont know if the call is failing before it sends the DNIS or DNIS is the problem I dont know enough about e&m.

voice-port 1/0:0

translate called 1

bearer-cap Speech

!

!

!

!

dial-peer voice 9 pots

tone ringback alert-no-PI

destination-pattern 9.T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

progress_ind disconnect enable 8

fax rate disable

direct-inward-dial

forward-digits 11

This is the voip dial-peer

dial-peer voice 101 voip

preference 1

destination-pattern 23T

progress_ind setup enable 3

modem passthrough nse codec g711ulaw

voice-class codec 1

session target ipv4:10.3.1.14

incoming called-number .

dtmf-relay h245-alphanumeric

fax rate disable

no vad

An ideas greatly appreciated.

1 REPLY
Community Member

Re: T1 e&m - 2 way problems. Urgent Please!

Found it it was the direct-inward-dial copied from a pri install!!

Doh

117
Views
0
Helpful
1
Replies
CreatePlease to create content