Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

T1/e1 Card installation on UC560 VWIC slot

Can any body guide how much time is consumed in installation of T1/E1 card on VWIC slot or any one having a document of the steps required.

Regards,

Rachna

2 REPLIES
Green

T1/e1 Card installation on UC560 VWIC slot

Rachna,

I reckon you need 1/2 hour for the physical work.

I can not see anything that says HOT insert of cards therefore I would definitely power the box down.

1) Save config.

copy run start

2) Power down

3) Insert E1 card

4) Power Up.

5) Allow to load and verify your existing service is valid

E.g. Are the phones working etc etc.

6) Verify the UC560 is seeing the new E1 card.

Show version

show diag

I all GOOD you can then configure the E1 , dial peers etc etc

I have found a couple of links that may help you

http://www.cisco.com/en/US/docs/voice_ip_comm/sbcs/uc500/hardware/quick/guide/UC560_Quick_Start.pdf

http://www.uc560.com/#wp9000470

HTH

Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
New Member

T1/e1 Card installation on UC560 VWIC slot

Hi Thanks Alex,

I will try that.

Regards,

Rachna

845
Views
2
Helpful
2
Replies
CreatePlease login to create content