04-12-2009 11:32 PM - edited 03-15-2019 05:26 PM
Hi, dear gurus!
How can i perform a http request in TCL? is it possibble? In my case I cannot use vxml dialog and cisco-data tag, because this request must be performed after ev_disconnect recieved, and no call leg exists to proceed the dialog (leg vxmldialog $leg_id).
Platform is 2811, IOS: c2800nm-advipservicesk9-mz.124-11.XW10.bin
If it is possible, pls give me the command syntax..
Solved! Go to Solution.
04-12-2009 11:50 PM
The commands are explained in the tcl/ivr manual that you should have already.
For an example see:
04-12-2009 11:50 PM
The commands are explained in the tcl/ivr manual that you should have already.
For an example see:
04-13-2009 12:01 AM
thanks, Paolo!
i'v read about http commands on cisco.com, but there were no examples ans syntax.
04-13-2009 12:06 AM
Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: