Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Tcl IVR --- http request (get method)

Hi, dear gurus!

How can i perform a http request in TCL? is it possibble? In my case I cannot use vxml dialog and cisco-data tag, because this request must be performed after ev_disconnect recieved, and no call leg exists to proceed the dialog (leg vxmldialog $leg_id).

Platform is 2811, IOS: c2800nm-advipservicesk9-mz.124-11.XW10.bin

If it is possible, pls give me the command syntax..

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Tcl IVR --- http request (get method)

The commands are explained in the tcl/ivr manual that you should have already.

For an example see:

http://pbevila.fastmail.fm/public/number2name-http.tcl

3 REPLIES
Hall of Fame Super Gold

Re: Tcl IVR --- http request (get method)

The commands are explained in the tcl/ivr manual that you should have already.

For an example see:

http://pbevila.fastmail.fm/public/number2name-http.tcl

New Member

Re: Tcl IVR --- http request (get method)

thanks, Paolo!

i'v read about http commands on cisco.com, but there were no examples ans syntax.

Hall of Fame Super Gold

Re: Tcl IVR --- http request (get method)

Thanks for the nice rating and good luck!

481
Views
0
Helpful
3
Replies
CreatePlease login to create content