Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

TCL script problem with CUCM 7.0

Hi,

I have configured CUCM 7.0 cluster, H.323 voice GW (3845 router with VWIC2-2MFT-T1/E1 card). Ihave no IVR. So, I have configured default TCL script version 2.1.2.2 on the Gateway. It is working fine with the option dial by extension, but when I press 0 for operator, it is not working & also hunt is not working. But my dial-peer configuration for operator is ok, as I can dial the operator from dial by extension option.

I need the operator option urgently. pls. help me.

3 REPLIES
Hall of Fame Super Gold

Re: TCL script problem with CUCM 7.0

Likely it is not configured correctly, you always need to post configuration when dealing with routers.

New Member

Re: TCL script problem with CUCM 7.0

router config is attached

Hall of Fame Super Gold

Re: TCL script problem with CUCM 7.0

Since you are using FXO, you need to remove "param aa-pilot". If still problems, collect "debug voice application script" with "term mon".

181
Views
0
Helpful
3
Replies
CreatePlease to create content