TCL Script unable to transfer call (its-CISCO.18.104.22.168.tcl)
I am using the its-CISCO.22.214.171.124.tcl script to receive a call on a specific dial-peer. When it is hit it is playing the welcome prompt, but if I try to dial any extension no it's not even waiting for the 2nd digit it's saying destination is not reachable even it is unable to transfer the call to the operator. Can anyone please help on this?
My scenario is :
PRI -> MGCP Gateway-1 -> CUCM 8.5 -> SIP TRUNK -> Gateway-1 - > inbound dial-peer -> script plays welcome prompt - X-- nothing after that.. Call get's disconnected.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.