Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Anonymous
N/A

tech-prefix gateway selection failed

Hi,

I have a CME router connecting to the gatekeeper and i have made a trunk from CCM to gatekeeper

Config :-

CME

dial-peer voice 1 voip

destination-pattern [1-2]...$

voice-class codec 1

session target ras

tech-prefix 1

gatekeeper

show gatekeeper endpoints

GATEKEEPER ENDPOINT REGISTRATION

================================

CallSignalAddr Port RASSignalAddr Port Zone Name Type Flags

--------------- ----- --------------- ----- --------- ---- -----

10.1.202.1 1720 10.1.202.1 52683 cme VOIP-GW

H323-ID: CME-HKG

Voice Capacity Max.= Avail.= Current.= 0

10.1.200.20 56014 10.1.200.20 51209 ccievoice3 VOIP-GW

H323-ID: HQ_Trunk_2

Voice Capacity Max.= Avail.= Current.= 0

10.1.200.21 52699 10.1.200.21 51483 ccievoice3 VOIP-GW

H323-ID: HQ_Trunk_1

Voice Capacity Max.= Avail.= Current.= 0

Total number of active registrations = 3

in CCM

I have made a inbound translation pattern.

My translation pattern/ is ok my css is ok but still call are not rounting to the ip phone.

Also when i am doing outbound i am not be able to call to cme

The error message is

*Mar 18 10:02:22.582: rassrv_get_addrinfo: (11005) Matched tech-prefix 1

*Mar 18 10:02:22.582: rassrv_get_addrinfo: (11005) unresolved zone prefix, using

source zone cme

*Mar 18 10:02:22.582: rassrv_arq_select_viazone: about to check the source side,

src_zonep=0x46B29DBC

*Mar 18 10:02:22.582: rassrv_arq_select_viazone: matched zone is cme, and z_invi

anamelen=0

*Mar 18 10:02:22.582: rassrv_arq_select_viazone: about to check the destination

side, dst_zonep=0x46B29DBC

--More--

*Mar 18 10:02:22.582: rassrv_arq_select_viazone: matched zone is cme, and z_outv

ianamelen=0

*Mar 18 10:02:22.582: rassrv_get_addrinfo: (11005) tech-prefix gateway selection

failed.

I wanted to want is tech-prefix gateway selection failed.

As i dont want to use zone prefix or default prefix in gatekeeper

I know its archievable my still its not working.

Can anyone please help me fast.

2 REPLIES
Bronze

Re: tech-prefix gateway selection failed

Tech prefix will not work when the E164 registration is enabled and the gateway has E164-ids available. You can use either "e164 register" or "tech prefix” but not both.

Make sure you have only one local zone if there is only ONE gatekeeper.

Make sure your CallManager has been properly configure under the Device>Gatekeeper Option

Community Member

Re: tech-prefix gateway selection failed

Are you still having issues here? Send me an email to jdelgado@redesfusionet.com I will give you a hand

452
Views
0
Helpful
2
Replies
CreatePlease to create content