We have a TEHO issue. It consit on that we are getting ARJ: unknown address and no default technology defined, when I send a call from a CallManager 555002145788320, where the zone prefix is zone prefix MCK_CCM 555500.......... gw-priority 10 and I have a Route pattern on called party Callmanager 55500.XXXXXXXXXX for receive the call, doing a Strip: predot and prefix digit 9 (on called party) in order to reach the PSTN
What command I have to add on the Gatekeeper? We are currently using gw-type-prefix 1#* default-technology on the GK and the trunk configuration into the Callmanagers. It is working for other zones pointed to the same called party callmanager like 33... or 35... (5 digit extension, but the zone that have more dots must to reach the PSTN and not an extension)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...