"Do you have the possibility to have your gateway configured in a way, that tells us that the dialed number is complete? Some kind of "sending-complete" notification..?"
Our problem is the following: On international calls, when the call setup exceedes 15 sec, it gets disconnected. This problem is most noticable on calls to international mobile numbers. International landline calls sets up much quicker ( usually within 8-10 sec), and only rarely fails. The Telco acknowledge this, but asks us if it is possible for us to give them somekind of "notification" that the dialed string is completed. This would make them able to route the call faster, and hopefully within the timeframe.
So, our gateway is a Cisco 2800, with ios: c2800nm-spservicesk9-mz.124-25b
Anyone that could give us some hints on how to help the Telco out?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...