I've got a 2800 ISR setup for 8 POTS lines, this is for a remote site opening up soon. The remote site will have 8 POTS lines running into a pair of 4 port FXO's. My question is this; how can I test to see that the lines are hunting properly here in the office? If I had 8 phone lines I'd just pop'em in but I only have 2 lines that I can test with.
You can run 'debug voip ccapi inout' and 'debug vpm sig' during a test call. You should see the call attempt to go out the port and get 'no circuit.' It will then hunt to the next dial-peer match, and try again.
You can also use 'sh dialplan number #' to make sure that you are matching a dial-peer for every port.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...