Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

the ip phones could not call the analog phones

Hi

I configured the router 2801 with h323 and the ip phones registered automatically and the anlog phones did not register automatically with the callmanager. The ip phones could call one another but the ip phones could not call the analog phones. Pls l need  your advise.

Ojay

5 REPLIES
Blue

the ip phones could not call the analog phones

HI,

How are analog phones connected. Are analog phone able to call Ip phone?

regards

Ronak Patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

the ip phones could not call the analog phones

Hi

the analog phones could not call the ip phones at all, but the ip phones were registered automatically with the callmanager 8.0.2 and the callmanager was able to give the ip phones extension numbers automatically which l used to call each other and they were all calling each other and l mean the ip phones. But the analog phones did not register with the callmanager but the two analog phones that l connected to the VIC4-FXS were able to call each other and that is the analog phones. But the two analog phones were not able to call any of the ip phones which is a puzzle to me. I tried both ways to call the analog and the ip phones but there was no answer. In these scinairo l was using h323 to connect the callmanager to the gateway which is the router 2801.

Blue

the ip phones could not call the analog phones

Hi,

Have you configured dialpeers towards Cisco CUCM and also Add this router as h323 gateway in CUCM. Also create route pattern in CUCM which points to this h323 gateway.

http://www.cisco.com/en/US/docs/ios/12_2/voice/configuration/guide/vvf323gw.html

Regards

Ronak patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

Re: the ip phones could not call the analog phones

No the ip phone cannot call the analog phone vice visa.

Date: Tue, 28 Feb 2012 06:19:17 -0700

From: supportforums-donotreply@supportforums.cisco.com

To: oojuribiodun@hotmail.com

Subject: - Re: the ip phones could not call the analog phones

Home

Re: the ip phones could not call the analog phones

created by Ronak Patel in IP Telephony - View the full discussion

HI,

How are analog phones connected. Are analog phone able to call Ip phone?

regards

Ronak Patel

Reply to this message by going to Home

Start a new discussion in IP Telephony at Home

the ip phones could not call the analog phones

Hi,

Could you please add the below Voice port comand and check,

voice-port 0/0/0

.

.

Reference :

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dp_app_a.html

Hope it helps,

Anand

236
Views
0
Helpful
5
Replies