We had a consultant install our Cisco UCM system (we have upgraded once and are running 7.1.3 now). I am now learning and administering the system but I have never added a whole new site phones and all. I have installed lots of phones and mailboxes with Unity but my problem is with the higher level pieces.
I know that I have to set up a new region, MRGL, Location, SRST Reference, Physical Location, Device Mobility Group, along with all of the call routing and device information. My question is that when I try to get started it is like the begat verses in the Bible. When I open up one of these items to add it has other things that I needed to add before hand. Is there anything available that will give me a "pecking order" of entries that I have to make when setting up a new site for Call Manager and Unity too for that matter.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...