Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Third-party SIP phones and UCM 6.1

Hi! I try to register SIP phone. I configured UCM End user and other settings like was discribed in a cisco's guide about SIP-phones. But redistration failed. It is not a network communication problem. I find this error in UCM logs "Rejecting foreign host/domain" about my SIP-phone. How can I find out, what does it means? How can I debug SIP-registration on UCM? Is it possible to get standart SIP error codes from UCM?

Hall of Fame Super Silver

Re: Third-party SIP phones and UCM 6.1

Hello ,

CUCM 6.1.x should support SIP digest

SIP digest authentication is specified in RFC 3261 and RFC 2617. It is based on a client/server

model, in which the server challenges and the client responds, and provides authentication of

SIP messages by a username and a keyed hash.

Hope to help


New Member

Re: Third-party SIP phones and UCM 6.1

Yes, UCM works fine with SIP. I find out that my problem is NAT. It's not a problem with SIP digest anymore.


I create static NAT on ASA to redirect SIP udp 5060 to UCM. It work fine, BUT: UCM reseve SIP packets with destination address of ASA5510's outside interface inside SIP packet and reject it. ASA doesn't do NAT inside SIP data, It does NAT only for IP packet.

New Member

Re: Third-party SIP phones and UCM 6.1


Can you please show me how to setup SJPhone on HP IPAQ using SIP with CUCM 5.1??

Best regards


Re: Third-party SIP phones and UCM 6.1


Can you post the configuration you are using for the ASA?


Luis Sandi


P.S Please mark this question as answered if it has been resolved. Do rate helpful posts.