Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

time based redirection to external Number

Hi,

i added a translation pattern on CCM6.01 for a specific extension based on offwork hours. This pattern should call an external Number.

The internal Extension 99 are translated from .99 to external Number on called party transformation and discard predot digits. It does'nt work.

How should the pattern formed to fulfill this issue.

regards

Ronny

8 REPLIES
Cisco Employee

Re: time based redirection to external Number

TP = DN you want to re-route

called party = external phone number as you would dial it from the phone

CSS = one that can reach the PSTN thru your route patterns

how do you have this configured??

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: time based redirection to external Number

TP = DN (99)

called Party = 0 for PSTN-Access + external Number

CSS = All_Allowed

But i'm not sure about the Route Pattern. I created a Partitiion, workhours_only, but the call does'nt start at this time to outside.

If i choose a Partition without restrictions, then the call will start.

regards

Ronny

Cisco Employee

Re: time based redirection to external Number

then i would check the TOD configuration and make sure the translation pattern becomes active when it should

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: time based redirection to external Number

Hi,

i have just 2 time configs:

Workdays 8 am to 8 pm and

other times and weekend.

How can i test the partition config at another way then the TP?

regards

Ronny

Cisco Employee

Re: time based redirection to external Number

use DNA to test the config

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: time based redirection to external Number

But i can test dialout Numbers. i Want to test incoming Numbers from Gateway.

regards

Ronny

Cisco Employee

Re: time based redirection to external Number

select the GW as the call source

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: time based redirection to external Number

OK, It seems a offset to the system time to exist, bute i cannot resolve this actually.

Some Patitions doe'snt work.

Any Ideas?

ciao

Ronny

151
Views
0
Helpful
8
Replies
CreatePlease to create content