cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
307
Views
0
Helpful
3
Replies

Time is not correct in CME even though it is right on the router it runs from

Y W
Level 1
Level 1

Hi all,

We have a 2911 that is running CME on top of. The router time is correct but within the CME GUI it is one hour fast. I checked all the setting with timezone and others and it seems to be correct.

In the GUI i tried to change the time and it will just revert whenever I hit apply. I enabled the setting that allows change time in GUI.

Please see attached

any suggestions would be greatly appreciated.

 

3 Replies 3

Dragan Ilic
Level 4
Level 4

Could you try:

conf t

telephony service

time-zone ... command

HTH,

Dragan

HTH,
Dragan

Dragan is right,

Please check a few syntax examples: http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/command/reference/cme_cr/cme_t1ht.html#wp1056604

Y W
Level 1
Level 1

Hi,

I did enter the time-zone info under the telephony-service configuration mode. just to be sure i did it again.

same effect, the router from cli will display the correct time, the phones will display the correct time, but if you goto http://routerip/ccme.html and click on system the time is 1 hour faster.

 

unity which syncs time from this router (set as ntp master) will also have timestamp 1 hour fast.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: