Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Time ring IP Phone

Hello,

When I call an IP Phone the phone ring only four times. How to increase the number of ring before the hungup?

I have try the command timeouts ring 60 without found a solution.

Regards

1 REPLY
Hall of Fame Super Red

Re: Time ring IP Phone

Hi Pascal,

This may be where your current 4 ring setting is coming from (you probably have this set as 10-12 seconds). Have a look;

call-forward noan

To configure call forwarding so that incoming calls to an extension (ephone-dn) that does not answer are forwarded to another number, use the call-forward noan command in ephone-dn or ephone-dn-template configuration mode. To disable call forwarding, use the no form of this command.

call-forward noan target-number timeout seconds

timeout seconds - Sets the duration that a call can ring with no answer before the call is forwarded to the target number. Range is from 3 to 60000. There is no default value.

From this good CME doc;

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_c1ht.html#wp1063669

Hope this helps!

Rob

527
Views
0
Helpful
1
Replies
CreatePlease to create content