I have had this issue for over a year with one client!! Its making me want to scream!
They have a 2801 running 12.4(3) code and CME 3.3...they have 3 7970s and for the LIFE of me I can't figure out why I can't get the clock to be correct on them.
I have gone through the troubleshooting guides that are out there and tried off set the incorrect time with the time-zone command but to no avail.
When i issue the show telephony-service tftp-bindings command, i dont see the SEP file for any of the 3 7970s that they have. The troubleshooting guide says you should see them, but not what to do if you don't.
TAC had no clue, so i am turning to our community.
Please type 'debug tftp events' and 'terminal monitor', then restart the phone. Make sure you have 'type 7970' under 'ephone XXX'. Post the result here. You will see which config file is given to the phones, to start with.
I have done this multiple times already and its pulling some default xml file, not the 7970xmldefault file. No SEP files exist either in the tftp-bindings...I have opened another TAC case and they too can't seem to figure out what it is yet...ODD!!!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...