Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Transcoder question CUCM 6

I see from RTMT that TranscoderResourceAvaible is 6

Is it possible increase this number?

6 REPLIES
New Member

Re: Transcoder question CUCM 6

Any answer?

Cisco Employee

Re: Transcoder question CUCM 6

yes, configure more sessions on your XCODER

it's pretty obvious

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Transcoder question CUCM 6

If I increase this parameter, will everything work fine?

Isn't XCODER sessions depend on other voice services?

I suppose that If I increase XCODER session, something else begin work worse?

Can you explain this step in more detail or give needed link?

thank you!

Hall of Fame Super Silver

Re: Transcoder question CUCM 6

It depends on your available PVDMs in the router (hardware), to increase it you need to have them. The router will tell you if you do or not when you go to re-configure them.

HTH,

Chris

Cisco Employee

Re: Transcoder question CUCM 6

i assume you think this is configured on the CUCM server, NO. this is configured on ISRs with PDVMs, and won't cause anything to work worse

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Transcoder question CUCM 6

I understand the procedure of configuration XCODERS.

How many XCODERs can configure on CUCM, as I understand this XCODERs are used by MRGL -> Device Pools.. so only 1 XCODER can work at a time?

An other question: to configurate fault tolerance should I configure second XCODER?

187
Views
3
Helpful
6
Replies
CreatePlease login to create content