Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

transcoding between g.723 and g.711 and/or g.729

Is there any way that I can do transcoding and conferencing between G.723 to and from G.711 and /or G.729 ?

Thanks.,

5 REPLIES
Green

Re: transcoding between g.723 and g.711 and/or g.729

If using cucm, you can setup regions accordingly and have proper transcoders that support both codecs

check cucm srnd media resources section

New Member

Re: transcoding between g.723 and g.711 and/or g.729

I was just trying to configure HW media resource ( 28XX router) using Cisco Online DSP calculator tool. Under the transcoding and coinferencing seciton it never shows g.723 selections. Only g.711 and g.729 are shown.

Green

Re: transcoding between g.723 and g.711 and/or g.729

New Member

Re: transcoding between g.723 and g.711 and/or g.729

I do not have catalyst switch in this particular installation . Is there any way that I can configure a router-based conferancing resource for this requirement ?

Green

Re: transcoding between g.723 and g.711 and/or g.729

no

264
Views
0
Helpful
5
Replies
CreatePlease to create content