Site A and B are in the same CM cluster. CM cluster communicates to the CME site using a GK. All inter-site communications have to use g729. I have to use MTP on the trunk for the supplementary services but it is creating transcoding problems for me as MTP on CM only supports g711. I configured a transcoder at Site A and Site A can talk to CME site properly by using the transcoder. Site B is configured to use G729 with Site A/CME and with the transcoder. When I try to call from Site B to CME , calls are failing as the transcoder is rejecting the call. I am not sure why it rejects the call but I am assuming that as both legs of the call are trying to use the same codec (g729) , it does not find itself useful and does not want participate to the call. If I configure the router as software MTP with g729 support, it may start to work but I want to eliminate that configuration. Is there any easier way or am I making something wrong here ?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...