Hello, My router 1700 has 1 fxs port and 1 fxo port.. fxs is directly connected to phone and fxo to pabx(extension number 100). i can call to pabx user by using dialpeer pots but i have to connect twice..i mean when pickup the phone(on fxs, i press 100 then get another tone then press the intended pabx extension (ex:101). i want when i pickup the phone(fxs) i only press 100101 to get the pabx user ring.. not press 100 then press 101... anyone helps? Thank you ;)
check you config. under the dial-peer for FXO, configure "no digit-strip", or "destination-pattern 1..." Please familiarize yourself with the way digits are absorbed or forwarded by DP's, this is in the manual.
I imagine this is for a lab. For production environment, try to avoid connecting to the PBX with FXS/FXO, because there are a lot of problem in doing so. You should use iSDN whenever possible.
hi beviacqua. yes i think i show know about absorbed and dp. i am confused about dot2 or T. would you please let me know where is the good manual for me to start? hmm.. is the pvdm and dsp is the same thing. how to calculate how may pvdm and dsp to support voice channel? tx very much for your kind :)
if you are calling variable-length numbers, you must use T at the end. What people often doesn't to, is to put first a fixed digit as prefix, then as many dots as the minimum number of digits following that prefix, perhaps three or four. That will make so an fastbusy is returned for misdialed calls and is a more accurate DP.
Yes pvdm's are codecs. Yo do "show diag" to see what you have in the router. For PVDM2 the digit in the part number indicates how many channels of G.711 and G.729 you can support. For other DSP or application the calculation is more complicated.
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...