12-09-2013 07:53 AM - edited 03-16-2019 08:46 PM
internal extenson is 53XX-55XX and external line is 3670100-3670350,how can I configure translation to make PSTN Directly call internal extensions ?The Router is 2911 and line is E1.
thx!
12-09-2013 08:16 AM
Start by mentioning the call control agent and version.
HTH
java
if this helps, please rate
www.cisco.com/go/pdihelpdesk
12-09-2013 08:28 AM
Hello Fog,
You will need a translation rule, it pretty simple
if you have an H323 VGW, apply this:
first of all, you need to make incoming phone call and run " debug isdn q931" on the VGW, make sure you " term mon" the logs.
- you only can make this DID to only 250 extention as you have only 250 number, you have only 5300 to 5550
- check the number sent by Teleco. " let's say it's the last three digits 100, 101, 1xx, 2xx, and 3xx"
- at the global configuration mode do the following:
translation-rule 1
rule 1 /1\(..\)/ /53\1/
rule 2 /2\(..\)/ /54\1/
rule 3 /3\(..\)/ /55\1/
exit
translation profile voice DID
translate called 1
- Under the E1 port
voice-port 0/0/0:15
translation-profile incoming DID
if Telecom sends the full number, so you need to use this translation rule
rule 1 /36701\(..\)/ /53\1/
rule 2 /36702\(..\)/ /54\1/
rule 3 /36703\(..\)/ /55\1/
please check that and let me know.
Regards,
Mohamed Helmy
12-09-2013 08:43 AM
so sorry,the E1 line is r2
12-09-2013 09:08 AM
Hello Fog,
it doesn't matter, just give it a try
Regards,
Mohamed Helmy
12-19-2013 05:42 AM
Hello Fog,
please keep me updated
Regards,
Mohamed Helmy
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: