Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Translating numbers beginning with +

Hi,

I have a problem with a AS5400. I'm trying to translate incoming numbers that start with +, e.g. +4631123456.

The rule look like this:

voice translation-rule 3

rule 1 /^\+46/ /0/ type any national plan any isdn
voice translation-profile sip2pstn
translate called 3

The outcome I want is 031123456. The command    test voice translation-rule 3 +4631123456   shows that the rule works.

The problem is that the + seems to disappear right before the translation rule is applied, and added afterwards if there isn't a match.

If i remove the + from the rule I get 031123456, but that isn't a perfect solution, since I then can't match local or special numbers, e.g. 112 or 911.

What is removing the +, and how can I stop it from doing that?

/ Oscar Ekeroth

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Translating numbers beginning with +

At the present, translation rules do not support the + character.

So, you can only make them work based on number lenght, patterns, type, etc.

The other alternative, would be a custom TCL/IVR script, that can do anything.

4 REPLIES
Hall of Fame Super Gold

Re: Translating numbers beginning with +

At the present, translation rules do not support the + character.

So, you can only make them work based on number lenght, patterns, type, etc.

The other alternative, would be a custom TCL/IVR script, that can do anything.

New Member

Re: Translating numbers beginning with +

Thank you for your fast answer.

I have some experience with TCL, so that might be a solution. But I've never used it in a Cisco gateway, so do you know any good help site where I might find examples of similar scripts?

/ Oscar Ekeroth

Hall of Fame Super Gold

Re: Translating numbers beginning with +

I personally write TCL/IVR scripts for any purpose

www.ciscoscripts.com

The standard reference and examples, are the Cisco TCL/IVR documentation.

Hall of Fame Super Gold

Re: Translating numbers beginning with +

I was also thinking you could try something with SIP profiles, but have no specific expereince.

Thanks for the nice rating and good luck!

441
Views
5
Helpful
4
Replies