Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Silver

Translation Patterns- timers

I`m using TP`s to configure the cluster- all my internal calls go to the TP against a Specific Pattern and get routed correctly however there is a delay going through the TP`s - is there a setting which decreases it - by default the Urget is ticked and it is not the 302 timer- thanks

3 REPLIES
Cisco Employee

Re: Translation Patterns- timers

TP do not have IDT, there must be something else that causes the IDT on your system as after the called party is translated it's subject to DA again.

look at the route plan report for overlapping

thousands of possible options can cause some delay

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Silver

Re: Translation Patterns- timers

There are other matches based upon the resultant number however only around 7 of the possible 16 are matched due to their Partitions only being the CSS of the TP . I know that TP`s have the potential to loop around 15 x. Is this delay normal in that it is quite noticeable

Re: Translation Patterns- timers

try to decrease the inter digit time out

127
Views
0
Helpful
3
Replies
CreatePlease to create content