I am having an issue where internal numbers are not showing up on caller ID as their DiD and just the last four digits. I have looked at Translations and transformations configurations and examples. I tried to apply them and am not getting anywhere. Any help would be great. I have a CUCM 9.1.1000 installed.
We currently have a Siemens 5k switch that we have created a SIP trunk connection with. All our out going calls and internal calls that are not setup on the UCM go over this SIP trunk. The calls are being made from Cisco IP phones and are going out to a cell phone. When i dial from ext 5100 the caller ID shows 5100 on the cell phone that i am calling when i need the caller id to show 2519281234. When i make a call from a DiD 2511234567 the caller id show 4567 and not the entire DiD number.
I have tried setting up a Translation Pattern and Transformation Pattern and i am not able to get the full 10 digit number to show up on the other end.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...